The pedestal range from Impertek comprises three types, namely the Jack Supports, MegaMart series, and Balance line [new!]. Jack Supports have been on offer since 1997 and are available in a range from 35 to 380mm. This original range has been adapted constantly over time to meet market needs and demands. A few months ago, they added more new products and accessories, including an extension with screws from 210 to 380mm, meaning an increase of 170mm. This makes it possible to offset big differences in height with just one pro-duct; this greatly helps logistical organisation on site. In October 2008, lmpertek launched the MegaMart with heights starting from 22mm for the lowest supports up to 1020mm for the highest. Here, too, they have considered the logistical organisation on site. For example, if you start with the fourth size [115-220mm], it is possible to achieve the final height with various extensions [100mm/extension]. The fifth measure goes from 215 to 320mm) and the sixth from 315 to 420mm until you finally reach the height of 1020mm. To correct the surface slope, lmpertek offers a micro-millimetric slope corrector. The Balance line is new; this is a product with a self-levelling head and specifically suitable for situations where there are drainage channels.
