Pvc with knock-out sistem
TUNNEL DISCS are used to connect the diffuser felting to the tunnel’s wall. Once the discs have been attached to the wall, the waterproof PVC sheet is welded to the discs themselves by using special hot air blowers.
The discs must be welded with a special gun with an explosive charge. Make sure there is a gap of about 70-80 cm between them when you install them. The whole surface of the discs must be welded to the PVC sheet to ensure greater watertightness in the event of pressure from standing water.
They are highly flexible even at low temperatures. Their physical and mechanical features remain over time. They are compatible with PVC synthetic waterproof felts.
The FLAT DISC is available with or without the in-built iron washer. The diameter of the pre-inserted washer is 21.75 mm with a hole in the middle of 5 or 6.4 mm. The flat disc is also available with a tear-off system. The flat discs with a tear-off system must only be welded on outside the holes designed for the tear.